HB M6 Roaster Unboxing 2. Prepare for unpacking after checking model, color and heat source are correct.Reserve the desired length of the pipe, cut it, and connect the other end to the air outlet next to the cooling plate in the same wayPlug in a 16A socket and you can start use (The gas version is a 10A socket)3. Use a flat-blade screwdriver to pry open the buckle under the box, flatten it with pliers, and then use a screwdriver to enlarge the gap.6. Press and hold the lock on the tensioner and push it up to an angle perpendicular to the ground to release the tensioner.4. Operate the 8 buckles under the wooden box in the same way to lift the wooden box, as shown in the figure.The machine manual and accessories are in a small box, please read the precautions on the small box carefully.9. After installing into the bean silo, gently tighten the fixing screws.1. Please check if the product model and color are correct before unpacking.5. Remove the screws fixing the fan and take out the fan.7. Move the machine to a suitable place, install the fan, and lightly tighten the screws.10. Install the exhaust pipe, clamp the pipe with the clamp in the small box, and tighten the screws. You can also adjust the direction of the air outlet according to your needs. Please try to avoid bending when the flue pipe goes outdoors.After the installation is complete, the air outlet of the cooling plate fan can also be connected to the smoke filter (not included with the box, can be purchased)Summary of accessories in the small box.